Skip to main navigation menu Skip to main content Skip to site footer

FABRICATION AND EVALUATION OF A LOW-COST ARC WELDING MACHINE FROM RECYCLED ELECTRICAL AND ELECTRONIC COMPONENTS

Abstract

This study reports the design, construction, and evaluation of an indigenous arc welding machine developed from recycled electrical and electronic components. Conducted in Delta State, Nigeria, the research adopted a developmental design approach to address the dual challenges of high equipment costs and electronic waste management. Transformer units, rectifier diodes, capacitors, and cooling systems were salvaged from discarded UPS units, microwave ovens, televisions, and computers, while the casing and frame were fabricated from mild steel scrap. The machine was designed for 220–240 V AC input, with an adjustable output of 50–180 A DC, and was evaluated on four parameters: output stability, weld quality, safety performance, and cost-effectiveness. Findings revealed that the indigenous machine-maintained voltage deviations within ±3% of a commercial unit, produced structurally sound welds on mild steel up to 12 mm thickness, operated safely through effective cooling and insulation, and achieved a 54.2% cost reduction compared with a commercial alternative. These results confirm the technical feasibility, safety, and economic viability of constructing welding machines from recycled components. The innovation enhances access to welding technology for technical education and small-scale fabrication, while contributing to sustainable development through e-waste recycling.

Keywords

Arc welding, indigenous machine, e-waste recycling, technical education, sustainable innovation, Nigeria

PDF